Quittintime: Cutting Thin Strips Tappered

The entire forum is open to viewing. But you must Register if you wish to post.

You are not logged in. [Login]

Main Index · Search · Active Topics
New user · Who's Online · FAQ · Calendar

Woodworking >> General Woodworking

Pages: 1

Bluegillman

Reged: May 18 2004
Posts: 6
Loc: Sweet Old Tinley Park, Illinoi...

Cutting Thin Strips Tappered
#8361 - Mon May 31 2004 10:40 PM

I had to figure out a way to cut a 1/8 thick by 3/4 wide by 24 long tappered from 3/4 on top to the bottom at 1/2 safely on the table saw. So I came up with those double side tape and sticked the strips tappered on to the four inch striaght wide board. Just push the straight board and the strip is being cutted tappered. It came out pretty easy and safely!

Post Extras:

calvin

Reged: Apr 29 2002
Posts: 2388
Loc: NW Ohio

Re: Cutting Thin Strips Tappered [Re: Bluegillman]
#8362 - Mon May 31 2004 10:55 PM

Thanks for the tip. I have always tacked a pc of luan to the board and run it through. That dbl stick tape is a good idea.

--------------------
Remodeling Contractor just outside the Glass City

Post Extras:

markcadioli

Reged: Apr 25 2002
Posts: 1405
Loc: Australia

Re: Cutting Thin Strips Tappered [Re: Bluegillman]
#8365 - Tue Jun 01 2004 04:08 AM

Bluegillman

email that to taunton..sometimes they pay for tips like that

regards

maRK

Post Extras:

Pages: 1

Extra information

0 registered and 2 anonymous users are browsing this forum.

Moderator:

Print Topic

Forum Permissions
      You cannot start new topics
      You cannot reply to topics
      HTML is disabled
      UBBCode is enabled

Rating:
Topic views: 2228

Quittintime

Please pay
our friends
a visit
(We do not
recieve income
from these links.)